Arc flash boundary10/26/2022 ![]() In addition, a qualified person must accompany unqualified persons. Persons crossing into the arc flash boundary are required to wear the appropriate Personal Protective Equipment (PPE) as determined by calculating methods contained in NFPA 70E. In some instances, calculations may decrease the boundary distance. NFPA 70E also allows the AFB to be calculated. NFPA 70E establishes the default arc flash boundary at 4 feet for low voltage (< 600V) systems where the total fault exposure is less than 5000 amperes-seconds (fault current in amperes multiplied by the upstream device clearing time in seconds). The AFB is a safe approach distance from energized equipment or parts. The arc flash boundary is based on voltage, the available fault current and the time it takes for the upstream protective device to operate and clear the fault. ![]() The arc flash hazard analysis should determine the arc flash boundary (AFB) and level of personal protective equipment (PPE) that the worker must wear. It is important to note that conductors and equipment are considered live when checking for voltage while putting equipment in a safe work condition. ![]() Until equipment is placed in a safe work condition (NFPA 70E 2000 Part II 2-1.1.3), it is considered live. Also, NFPA 70E 2000 requires that before a worker approaches exposed electric conductors or circuit parts that have not been placed in a safe work condition, a flash hazard assessment must be performed. The limited, restricted and prohibited approach boundaries are based on the voltage of the energized equipment. There are three shock approach boundaries (limited, restricted and prohibited) required to be observed in NFPA 70E 2000. NFPA 70E has developed requirements to reduce the risk of injury to workers due to shock and arc flash hazards. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |